Open the interactive guide to see each step on your Dome.
Please work through these troubleshooting steps in order.
-
Prepare the oven
Turn the oven off and let it cool fully. Remove the burner guard.
Have the new igniter, a new AAA battery and pliers ready.
-
Remove the igniter
Remove the display, battery cap and battery. Remove the plastic nut, then remove the igniter from the oven. Its three wires stay connected.
-
Reconnect each wire
With pliers, disconnect one plug from the old igniter and connect it to the matching pin on the new igniter before you disconnect the next. Grip the plug, not the wire.
-
Secure the igniter
Slide the new igniter into place and fully tighten the plastic nut. Fit the new battery, positive end out. Screw the cap on straight and securely, then refit the display.
-
Test the ignition
Firmly push and turn the dial to 9 o'clock. Hold it in until lit, up to 30 seconds, then 30 seconds more so the side pocket flame energises the FFD probe. It should click the whole time.
Not lit? Turn it off, wait 5 minutes, then try once more. Still not lit, or clicking stops? Continue.
-
Refit the burner guard and retest
Turn the oven off and let it cool. Refit the burner guard upright, behind the white ceramic, clear of the electrode.
Repeat the ignition test. Clicking stops? Contact the Gozney Team.
If you have any further problems, contact the Gozney Team.