Open the interactive guide to see each step on your Dome.
Please work through these troubleshooting steps in order.
-
Prepare the oven
Turn the oven off and let it cool. Remove the burner guard.
-
Test the ignition
Firmly push and turn the dial to 9 o'clock. Hold it in until lit, up to 30 seconds, then 30 seconds more so the side pocket flame energises the FFD probe. It should click the whole time.
Not lit? Turn it off, wait 5 minutes, then try once more. Still not lit, or it goes out? Continue.
-
Tighten the FFD back nut
Turn off the oven and gas. Let the oven cool.
Disconnect the gas cylinder and remove the display. Using a short 8 mm spanner, gently tighten the brass nut at the end of the ignition assembly.
-
Reconnect the gas and test
Refit the display and the burner guard. Keep the guard upright, behind the white ceramic and clear of the ignition electrode. Reconnect the gas and turn it on.
Repeat the ignition test. Flame did not stay lit? Contact the Gozney Team.
If you have any further problems, contact the Gozney Team.