Open the interactive guide to see each step on your Dome.
Please work through these troubleshooting steps in order.
-
Prepare the oven
Turn the oven off and let it cool fully. Remove the burner guard and fully disconnect the gas supply.
The gas supply will not be needed for this troubleshooting.
-
Test the ignition
With the gas disconnected, press the dial in firmly. Listen for clicking and look for a spark at the electrode.
Spark? Continue. No spark? Replace the battery in step 5.
-
Refit the burner guard
Refit the burner guard upright, behind the white ceramic, ensuring the guard is not touching the ignition electrode.
-
Retest the ignition
With the gas disconnected, press the dial in firmly. Listen for clicking and look for a spark.
Spark? You're done. No spark? Continue.
-
Exchange the ignition battery
Remove the display. Unscrew the battery cap on the right and check it has a metal spring.
Fit a new AAA battery, positive end out. Screw the cap on straight and securely, then refit the display. Make sure the burner guard is clear of the electrode.
Not working? Contact the Gozney Team.
-
Retest the ignition
With the gas disconnected, press the dial in firmly. Listen for clicking and look for a spark at the electrode.
Spark? You're done. No spark? Continue.
-
Check and adjust the electrode
Remove the burner guard. Inspect the ignition electrode height and alignment.
If needed, use pliers to gently move the electrode tip to 4 mm above the burner head.
-
Refit the burner guard
Refit the burner guard upright, behind the white ceramic, ensuring the guard is not touching the ignition electrode.
-
Retest the ignition
With the gas disconnected, press the dial in firmly. Listen for clicking and look for a spark at the electrode.
Spark? You're done. No spark? Continue.
-
Remove the igniter module
Remove the display, battery cap and battery. Remove the plastic nut securing the igniter module, then remove the igniter from the oven.
-
Reseat the three wires
With pliers, disconnect and reconnect each plug one at a time. Grip the plug, not the wire.
-
Refit the igniter
Slide the igniter back into place and fully tighten the plastic nut. Refit the battery, positive end out. Screw the cap on straight and securely, then refit the display.
-
Test the ignition final time
With the gas disconnected, press the dial in firmly. Listen for clicking and look for a spark at the electrode.
Clicking and a spark? You're done. No clicking or no spark? Contact the Gozney Team.
If you have any further problems, contact the Gozney Team.